07-09-2020 07:53 AM
Can someone please explain how to configure Servers and desktops in CML. I am unable to configure network parameters for these nodes, i.e. Static IP address and mask, DFGWY, etc... I keep getting permission denied. I've also tried the Alpine setup-interfaces utility which just throws up an error after I complete the setup stating the file already exists. An example of how to configure the network settings would be great!
07-09-2020 08:31 AM
ok I figured it out I think.
at the Linux command line type:
sudo ifconfig eth0 x.x.x.x netmask x.x.x.x
sudo route add default gw x.x.x.x eth0
I'm obviously a linux newbie. Apologies if this was obvious.
03-15-2022 08:37 AM
Super helpful. Thanks a lot!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide