cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
696
Views
0
Helpful
1
Replies

NxOS device in Devnet sandbox is not working.

colonsims
Level 1
Level 1

I received my vpn credentials and logged in successfully.  I could access all the devices except for the NxOS devices.  I even looked and the vrf table and the IP's for the devices are NOT present.  Anyone have any ideas??

 

dist-rtr02#sh ip route vrf Mgmt-intf

Routing Table: Mgmt-intf
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, m - OMP
n - NAT, Ni - NAT inside, No - NAT outside, Nd - NAT DIA
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
H - NHRP, G - NHRP registered, g - NHRP registration summary
o - ODR, P - periodic downloaded static route, l - LISP
a - application route
+ - replicated route, % - next hop override, p - overrides from PfR

Gateway of last resort is 10.10.20.254 to network 0.0.0.0

S* 0.0.0.0/0 [1/0] via 10.10.20.254
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 10.10.20.0/24 is directly connected, GigabitEthernet1
L 10.10.20.176/32 is directly connected, GigabitEthernet1

1 Reply 1

colonsims
Level 1
Level 1

I had to go through the Cisco Modeling Labs Server.  I got it to work.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: