I have a cisco router configured as client c and it has a vlan 50 subinterface configured with the ip then I have a servive provider that transports that traffic to me in layer 2 with vlan 1000, therefore it transports it as q in q. , then my final equipment receives it in a port where I have configured the following
encapsulation dot1q 1000 second-dot1q 50
that port makes a bridge with another port of the same equipment to take vlan 50 to the final client
My question is,
How do I create a bridge in a Cisco ASR 1001 with vlan 50 and verify how I have configured the q in q