04-07-2020 09:37 PM
Dear all. today i get such a message (The overall memory swap usage (11%) has exceeded the configured threshold value of 10%. ) from ESA very often. could you please tell me what kind of issue it is? thanks in advance
Solved! Go to Solution.
04-08-2020 01:14 AM - edited 04-08-2020 01:15 AM
Hi,
The swap alert received is informational alert. The system is designed to swap memory regularly, so some memory swapping is expected and is not an indication of problems with your appliance. Unless the system consistently swaps memory in high volumes, memory swapping is normal and expected behavior.
In order to stop such alerts, you can change the threshold value for the Memory Page swapping alert by following the below steps:
Log in to GUI-->System Administration-->System Health-->Edit Settings-->Memory Page swapping (Set the new threshold value, submit and commit the changes).
If the swap alert received the highest percentage the appliance generated is 11%, you can change the threshold to 15% after which won't receive any further alerts.
Cheers,
Pratham
04-08-2020 01:14 AM - edited 04-08-2020 01:15 AM
Hi,
The swap alert received is informational alert. The system is designed to swap memory regularly, so some memory swapping is expected and is not an indication of problems with your appliance. Unless the system consistently swaps memory in high volumes, memory swapping is normal and expected behavior.
In order to stop such alerts, you can change the threshold value for the Memory Page swapping alert by following the below steps:
Log in to GUI-->System Administration-->System Health-->Edit Settings-->Memory Page swapping (Set the new threshold value, submit and commit the changes).
If the swap alert received the highest percentage the appliance generated is 11%, you can change the threshold to 15% after which won't receive any further alerts.
Cheers,
Pratham
04-08-2020 01:31 AM
Thank you so much
12-23-2022 01:32 AM - edited 12-23-2022 01:35 AM
Hi,
thanks for this kind of solution, I increased the value already some times and currently I´m at 30% and alerts still started again.
Fri Dec 23 10:19:47 2022 : The overall memory swap usage (32%) has exceeded the configured threshold value of 30%.
Any else solutions? Or just increasing the alert value? We are already in planning to renew the appliances, I just want to get sure that no issue is expected.
Thanks in advance and regards
Wolfgang
12-23-2022 05:15 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide