How to enable web administration from CLI

[Loganathan1]

Hi There,

I have recently replaced a Management device due to H/W  failure at a remote site.

Am able to access the device from CLI whereas GUI is not connecting. How to check & enable the http/https access.

Thanks,

Logan

[Loganathan1]

Sorry for not mentioning the device description.

Its  Cisco M1070 Security Management(tm) Appliance

[dmccabej]

Hello,

This can be done from the CLI by using ifconfig -> edit. You would then select an Interface and proceed to enable/disable/edit/ETC any services you may or may not need on that IF. 

m100v-stage.lab.local> ifconfig


Currently configured interfaces:
1. Management (192.168.1.10/28 on Management: m100v-stage.lab.local)

Choose the operation you want to perform:
- NEW - Create a new interface.
- EDIT - Modify an interface.
- GROUPS - Define interface groups.
- DELETE - Remove an interface.
[]> edit

Enter the number of the interface you wish to edit.
[]> 1

Be sure to commit/save your changes when complete.

Thanks!

-Dennis M.