Power Supply

[thelmt_ironport]

I've done a fair amount of googling, searching the IronPort KB as well as these forums and have not found a specific Voltage setting for powering the C150's. I've found references to Amp draw at different loads as well as an older document for a C10 saying something to the effect of 'anything from 110 to 240'.

Are the power supplies that versitle? Would you get more life out of a power supply running it at a specific Voltage rather than at some other hypothetical voltage?

Thanks Gang,

The LMT

[Donald Nash]

I don't have any specific knowledge about the power supplies in a C150, but most modern power supplies are auto-ranging. If the C150 documentation doesn't mention input voltage, then don't worry about it. It'll work equally well anywhere in the 110 - 240 range.

[meyd45_ironport]

All IronPort PSUs are auto ranging.

[meyd45_ironport]

All IronPort PSUs are auto ranging.