cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to Cisco Firewalls Community


91
Views
0
Helpful
1
Replies
Highlighted
Enthusiast

ASA IPv6 Static Command Equivalent

Hi guys,

 

I am implementing IPv6 on a lab environment.  My ASA is running 8.2(5).  I am mapping the outside IP address 66.181.12.242 to 192.168.22.101 with the following command:

static (inside,outside) 66.181.12.242 192.168.22.101 netmask 255.255.255.255

I have given the inside host an IPv6 address of ABCD:192:168:22::101.  I want the ASA to translate ABCD:66:181:12::242 to the internal ABCD:192:168:22::101.  What is the equivalent command to do this in IPv6?

FYI, this is just a lab environment so the outside IP address isn't actually on the Internet.  For the purposes of this lab I need to translate IPv6.

 

Thanks!

Jeff

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Frequent Contributor

NAT for ipv6 in 8.2(5) is NOT

NAT for ipv6 in 8.2(5) is NOT SUPPORTED. You will have to upgrade your device to version 9.0 & up for ipv6-supported NAT commands.

Here's the link for more information :

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/release/notes/asarn90.html#pgfId-684764

 

Look for New features under version 9.0(1) - NAT support for IPv6

Manish

View solution in original post

1 REPLY 1
Frequent Contributor

NAT for ipv6 in 8.2(5) is NOT

NAT for ipv6 in 8.2(5) is NOT SUPPORTED. You will have to upgrade your device to version 9.0 & up for ipv6-supported NAT commands.

Here's the link for more information :

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/release/notes/asarn90.html#pgfId-684764

 

Look for New features under version 9.0(1) - NAT support for IPv6

Manish

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here