Translate Destination IP Address

[riosibuea]

Hello,

I would like to translate a matching destination IP Address from a specific source network to a specific destination IP Address.

Is this possible to be done on Cisco IOS Router?

[sooprasa]

Hello,

Could be a little more clear on your question please.

You can refer to the below mentioned document to configure NAT on IOS

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml

Regards,

Sooraj

P.S.: please mark this thread as answered if you  feel your query is resolved. Do rate helpful posts.

[mile.ljepojevic]

Yes and it is easy.

As a NAT source you can use extended access list:

ip access-list exte NATDST

permit ip SOURCE_IP SOURCE_WILDCARD DESTINATION_IP DESTIONATION_WILDCARD

ip nat inside source list NATDST pool WHICHEVERYOUDEFINED