05-18-2017 01:22 PM
What are the best practices for monitoring ISE using SNMP polling? I'm aware of this document:
SNMP Traps To Monitor Cisco ISE Processes
Unfortunately, Traps are not an option due to the tool used. So, I'm looking for a document regarding monitoring of the processes using SNMP polling, or otherwise other options for monitoring ISE health using polling.
Thanks.
Solved! Go to Solution.
05-19-2017 05:11 AM
The SNMP Agent on Cisco ISE provides read-only access to the following MIBs:
Appliance OIDs available in CISCO-PRODUCTS-MIB:
Additionally, hardware appliances have the CIMC which supports the Cisco UCS MIB Files
/Craig
05-19-2017 05:11 AM
The SNMP Agent on Cisco ISE provides read-only access to the following MIBs:
Appliance OIDs available in CISCO-PRODUCTS-MIB:
Additionally, hardware appliances have the CIMC which supports the Cisco UCS MIB Files
/Craig
05-22-2017 03:45 PM
Thanks Craig. One question though. The documentation for using SNMP traps to monitor ISE processes has this note:
"ISE does not have any MIB for process status or disk utilization. You cannot use snmp walk or snmp get command to query the process status or disk utilization. Cisco ISE uses OID HOST-RESOURCES-MIB::hrSWRunName, UCD_SNMP_OID:dskPercent, and HOST-RESOURCES-MIB:hrSWRunStatus for sending SNMP trap."
If I am understanding the note correctly, you can only use traps to monitor the ISE processes, is that correct? No process monitoring available via polling. Again, I may be understanding that note incorrectly.
But if so, from the list of MIBs that you provided, what other OIDs are recommended for monitoring the correct functioning of ISE nodes?
Thanks.
03-20-2018 02:51 PM
Good question!
03-20-2018 02:52 PM
Great info, thanks!
12-10-2019 07:07 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide