09-05-2018 11:19 PM
I have a cisco Sf250 Switch, all are working fine except one port. I have made it to work as a access port but it keeps changing to Trunk port over time. I have switched ports but to no avail.
Any help is appreciated,
Thanks in advanced.
09-05-2018 11:39 PM
show run configuration of the port and also detailed to have look.
09-06-2018 12:31 AM
Hi sumit.karki
if DTP " dynamic trunking protocol " is enabled on both end , it will be converted to Trunk mode , so if you want to disable this , you have to disable DTP .
09-12-2018 08:38 AM
Hello
I haven’t worked on these type of switches but if you have made this an access port how does end up being Trunk?
switchport mode access should disable any dtp so not to do as you are saying?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide