hello all, I read Cisco doco regarding power ignition on IR829. Once I enabled the power ignition, the off-timer starts kicking even though the router is still powered ON and it always had higher input voltage (12v) than the under-voltage value set (9). O... view more

This community is specific for general information of Cisco IoT Kinetic.   If you need any Kinetic information for developers, please go to For Developers IoT Kinetic Community (https://community.cisco.com/t5/cisco-kinetic/ct-p/5857j-dev-iot-kinetic)... view more

Having issues with the switch below detecting a PoE device and powering it. Device complies with the IEEE 802.3af/at standards, it works on a PoE injector. Its only drawing about 5.9 W. No configuration works, even if i set the draw manually.  See be... view more

Good evening,   I'm searching this value: how is the power dissipated (expressed in watt) by IE3000-8TC-E switch? Thank you in advance for your help Regards Alberto

I have a cisco Sf250 Switch, all are working fine except one port. I have made it to work as a access port but it keeps changing to Trunk port over time. I have switched ports but to no avail. Any help is appreciated, Thanks in advanced.