CISCO ASA-5525X ASDM 7.9(2) Restore from backup hangs at 98 percent

[HyosungUSA]

I have a working asa-5525x that I need to copy the image to another 5525x so I can install at another location.

Made a full backup using asdm and then tried restoring to a factory-default config, but the restore hangs at 98%.

Also tried copy and pasting the running config using the CLI and everything looks OK except the Site-to-Site VPN profiles are not

visible on the new asa, but if I try to add the profile back it says it already exists?

[balaji.bandi]

is the other ASA running the same Code? same specification?

[HyosungUSA]

OK, ran show run asdm on each box and they were different, one was running the open-jre version.

So I made sure each had the same image loaded by issuing "asdm image disk0:/asdm-792-152.bin" on each and now each are running the same image, also now the site-to-site VPN profiles are visible on 2nd box.

BUT when I try a full restore from a zip file it still hangs at 98%.

[balaji.bandi · Accepted solution]

May be looking hitting old bug, Try manually copy and paste the config

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCtg76211

[HyosungUSA]

Yep, That is how I got the config copied over cut and paste into CLI.

[HyosungUSA]

Also both are running the same asa9.9(2) binary