10-18-2013 09:47 AM - edited 03-16-2019 07:58 PM
Hi guys
I tring to configure my router (model 2600) as a call meneger using SIP protocol but i missing the command to register Directory Number
"voice register dn", i usring IOS image : "C2691-ADVENTERPRISEK9-M"
as shown here:
------------------------------------------------------
Router(config)#voic
Router(config)#voice re
Router(config)#voice register ?
pool Define pool tag
Router(config)#voice register
------------------------------------------------------
please can explian why the command relating to DN not appearing
Regarts
Sabah Awni
10-18-2013 08:57 PM
Sorry, let me just correct myself.
Please share the "show version" output along with "show run"
Advance Enterprise Services supports voice
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
10-19-2013 04:18 AM
thanks Jorge, i get the problem,
The 'voice register dn' command was introduced in 12.4(4)T and my version earlier version
----------------------------------------------------------------------------------------------------------------------------------------------------------------
Router#show version
Cisco IOS Software, C2600 Software (C2600-IPVOICE_IVS-M), Version 12.4(21a), RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Mon 29-Sep-08 15:25 by prod_rel_team
ROM: ROMMON Emulation Microcode
ROM: C2600 Software (C2600-IPVOICE_IVS-M), Version 12.4(21a), RELEASE SOFTWARE (fc1)
Router uptime is 4 minutes
System returned to ROM by unknown reload cause - suspect boot_data[BOOT_COUNT] 0x0, BOOT_COUNT 0, BOOTDATA 19
System image file is "tftp://255.255.255.255/unknow"
Cisco 2621 (MPC860) processor (revision 2.2) with 221184K/40960K bytes of memory.
Processor board ID FTX0945W0MY
M860 processor: part number 0, mask 0
2 FastEthernet interfaces
32K bytes of NVRAM.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2142
------------------------------------------------------------------------------------------------------------------------------------------------------------------------
10-20-2013 08:24 AM
Sabah,
I'm sorry for the bad news but the 2610 is been out of active development for some time now.
http://www.cisco.com/en/US/products/hw/routers/ps259/prod_eol_notice09186a008032d4c2.html
10-20-2013 10:43 AM
Indeed that's the problem
--
Jorge Armijo
Please remember to rate helpful responses and identify helpful or correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide