12-17-2013 02:41 AM - edited 03-16-2019 08:54 PM
Hi all,
I've connected my voice gateway to my home phone and to my CUCM.
The voice GW has a PLAR configured on the FXO port so incoming calls are forwarded to the my ip phone on the CUCM.
When I call my home, my ip phone rings and can establish a communication
My problem is with the call signaling:
If I call my home and end my call before someone picks up the IP phone, it keeps ringing!!
Also if in conversation, if I end the call, the CIPC just gives a busy tone but doesn't end the call; I 've to clear it maually.
Could you help to tune this up pls?
Cheers
12-17-2013 02:58 AM
Set the timeout value under voice port. See if this can help.
voice-port 0/0/1
timeouts interdigit ..
timeouts call-disconnect ..
timeouts ringing ..
timeouts wait-release ..
Rate all the helpful post.
Thanks
Manish
12-22-2013 03:52 AM
Hi Manish,
Thanks for the tips. It can help indeed but my issue was really to terminate a call by sending call termination message from the GW to CUCM not wait a certain amount of time before ending the call....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide