Hi Experts,
Please Refer the Attachment
We have an Cisco systems 2911 CME Router, there is 2 voice card installed each card have 4 FXO lines.
Now, If some calling From Outside to Internal IP Phones over PSTN lines Via FXO Card. Caller Number Its Not Appearing On the Telephone. its Showing Unknown Number. we had contact with PSTN they have already activated caller ID Feature moreover if connect the PSTN Analogue Line into a analog phone directly Number its Appearing During the Incoming Call.
Please Give suggestion for the same.....................
voice-port 0/0/0
supervisory disconnect dualtone mid-call
cptone BE
timeouts call-disconnect 0
timeouts wait-release 1
connection plar opx 155
impedance complex2
description ***POTS LINE 1***
caller-id enable
caller-id mode DTMF
caller-id alerting ring 2
!
voice-port 0/0/1
supervisory disconnect dualtone mid-call
cptone BE
timeouts call-disconnect 0
timeouts wait-release 1
connection plar opx 143
impedance complex2
description ***POTS LINE 1***
caller-id enable
caller-id mode DTMF
caller-id alerting ring 2
show inventory
NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"
PID: CISCO2911/K9 , VID: V02 , SN: FCZ1513213G
NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 0", DESCR: "2nd generation four port FXO voice interface daughtercard"
PID: VIC2-4FXO , VID: V04 , SN: FOC15121086
NAME: "2nd generation four port FXO voice interface daughtercard on Slot 0 SubSlot 1", DESCR: "2nd generation four port FXO voice interface daughtercard"
PID: VIC2-4FXO , VID: V04 , SN: FOC151210CX
NAME: "PVDM3 DSP DIMM with 16 Channels on Slot 0 SubSlot 4", DESCR: "PVDM3 DSP DIMM with 16 Channels"
PID: PVDM3-16 , VID: V01 , SN: FOC15094V2J
NAME: "Internal Services Module with Services Ready Engine on Slot 0", DESCR: "Internal Services Module with Services Ready Engine"
PID: ISM-SRE-300-K9 , VID: V02 , SN: FOC1813260K
NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"
PID: PWR-2911-AC , VID: V03, SN: AZS145202G9