Configuring CME 9 for Transcoding

[bob.bartlett]

I am trying to find guidance on how to configure the DSP resources to work in an environment where I can't map the resource to an actual interface with a MAC-Address but only to the Loopback interface.  Thanks...                  

[Jaime Valencia]

If you mean the dspfarm profile name which by best practice uses the MAC address from the interface you will be using to reach CUCM/CME, that is just a best practice, you can name them whatever you like.

You neven bind the profile to the MAC, you bind to a signaling interface for SCCP.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

[bob.bartlett]

I must use the Loopback interface as the CME interface and by using that I do not have a MAC Address to bind to in the MTP configuration.  that is my question is if using that interface what do i use for the Mac Address.

[etamminga]

You can name the transcoder whatever you want. Even your name would work, you don't need a MAC!

Sent from Cisco Technical Support iPad App