04-01-2021 04:02 PM
Hi all,
I have a 2811 router with a VIC2-2BRI-NT/TE. I want to connect a Swissvoice eurit 25 ISDN phone to the router, but when I configure the BRI 1/0/0 port in network side mode and connect the phone, the port doesnt bring up and the phone stay off.
The BRI 1/0/0 configuration:
no ip address
isdn protocol-emulate network
isdn layer1-emulate network
isdn incoming-voice voice
line-power
Im sure the phone is working correctly becaus its turn on if i connect it to an NT1 device.
Solved! Go to Solution.
04-02-2021 06:40 AM
I found the problem. The cable was wrong.
04-02-2021 01:05 AM
Hopefully someone who's actually done this will chip in. However what do you see under "sh isdn status" and from the debug "debug isdn q921"
04-02-2021 06:40 AM
I found the problem. The cable was wrong.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide