03-03-2013 01:59 AM - edited 03-16-2019 04:02 PM
Hi
I am having DTMF issues on a gateway connected to service provider over ISDN. I have copied the dial peers used below. I can see the DTMF digits hit the gateway though (ref debug below). I have attached config. Let me know if I can provide any additional information. Any help appreciated. Thanks
SHOW VOICE CALL STATUS
======================
0x20BEE 127F 0x46E59474 1/0/0:15.17 0/1:1 494 g711ulaw 20/1
DIAL PEERS USED
================
dial-peer voice 20 pots
preference 1
incoming called-number [1-4]..
direct-inward-dial
forward-digits all
dial-peer voice 1 voip
preference 1
destination-pattern [1-4]..
voice-class codec 99
session target ipv4:10.104.160.29
dtmf-relay h245-alphanumeric
no vad
DEBUG VOIP VTSP SESSION
=======================
*Mar 3 11:13:25.481: //134221/xxxxxxxxxxxx/VTSP:(1/0/0:15):28:1:4/vtsp_do_call_history:
Coder Rate=12
*Mar 3 11:13:25.769: //134223/804AD81F2D29/VTSP:(1/0/0:15):-1:0:0/vtsp_create_call_active_on_setup_req:
Target Carrier ID=
*Mar 3 11:13:25.769: //134223/804AD81F2D29/VTSP:(1/0/0:15):-1:0:0/vtsp_create_call_active_on_setup_req:
Source Carrier ID=
*Mar 3 11:13:26.789: //-1/3489F1A180AD/VTSP:(1/0/0:15):2:-1:-1/vtsp_do_normal_call_setup_ind:
IC State Machine (ICSM) Added
*Mar 3 11:13:26.797: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_spi_event_handler:
Event Category=1, Event=145
*Mar 3 11:13:28.905: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_save_tty_config:
Save TTY configuration
*Mar 3 11:13:28.905: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_set_tty_feat_param:
Set TTY feat parameters
*Mar 3 11:13:29.193: %ISDN-6-CONNECT: Interface Serial1/0/0:2 is now connected to 97317510400 N/A
*Mar 3 11:13:30.529: //134223/804AD81F2D29/VTSP:(1/0/0:15):30:1:1/vtsp_dsm_save_tty_config:
Save TTY configuration
*Mar 3 11:13:30.529: //134223/804AD81F2D29/VTSP:(1/0/0:15):30:1:1/vtsp_dsm_set_tty_feat_param:
Set TTY feat parameters
*Mar 3 11:13:37.709: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_begin_cb:
Begin Digit=5
*Mar 3 11:13:37.777: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_end_cb:
End Digit=5
*Mar 3 11:13:38.129: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_begin_cb:
Begin Digit=6
*Mar 3 11:13:38.197: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_end_cb:
End Digit=6
*Mar 3 11:13:38.461: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_begin_cb:
Begin Digit=6
*Mar 3 11:13:38.541: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_end_cb:
End Digit=6
*Mar 3 11:13:38.857: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_begin_cb:
Begin Digit=8
*Mar 3 11:13:38.941: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_end_cb:
End Digit=8
*Mar 3 11:13:39.301: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_begin_cb:
Begin Digit=#
*Mar 3 11:13:39.377: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_dsm_digit_end_cb:
End Digit=#
*Mar 3 11:13:45.281: %ISDN-6-DISCONNECT: Interface Serial1/0/0:2 disconnected from 97317510400 , call lasted 16 seconds
*Mar 3 11:13:45.293: //134224/3489F1A180AD/VTSP:(1/0/0:15):2:1:3/vtsp_do_call_history:
Coder Rate=5
03-03-2013 02:12 AM
DEBUG ISDN Q931 is posted below
===========================
*Mar 3 11:51:02.177: ISDN Se1/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x648D
Sending Complete
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98396
Exclusive, Channel 22
Progress Ind i = 0x8583 - Origination address is non-ISDN
Calling Party Number i = 0x1181, '97317510400'
Plan:ISDN, Type:International
Called Party Number i = 0x81, '494'
Plan:ISDN, Type:Unknown
*Mar 3 11:51:02.193: ISDN Se1/0/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xE48D
Channel ID i = 0xA98396
Exclusive, Channel 22
*Mar 3 11:51:03.473: ISDN Se1/0/0:15 Q931: TX -> ALERTING pd = 8 callref = 0xE48D
*Mar 3 11:51:04.253: ISDN Se1/0/0:15 Q931: TX -> CONNECT pd = 8 callref = 0xE48D
*Mar 3 11:51:04.529: ISDN Se1/0/0:15 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x648D
*Mar 3 11:51:04.533: ISDN Se1/0/0:15 **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 21 call id 0x40BE
*Mar 3 11:51:04.533: %ISDN-6-CONNECT: Interface Serial1/0/0:21 is now connected to 97317510400 N/A
*Mar 3 11:51:30.625: ISDN Se1/0/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x0 0x0, Calling num 6149122
*Mar 3 11:51:30.625: ISDN Se1/0/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x0 0x0, Called num 088880567528424
*Mar 3 11:51:30.625: ISDN Se1/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x02B4
Sending Complete
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA9839F
Exclusive, Channel 31
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x0081, '6149122'
Plan:Unknown, Type:Unknown
Called Party Number i = 0x80, '088880567528424'
Plan:Unknown, Type:Unknown
*Mar 3 11:51:31.009: ISDN Se1/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0x648D
Cause i = 0x8290 - Normal call clearing
Progress Ind i = 0x8288 - In-band info or appropriate now available
*Mar 3 11:51:31.013: %ISDN-6-DISCONNECT: Interface Serial1/0/0:21 disconnected from 97317510400 , call lasted 26 seconds
*Mar 3 11:51:31.013: ISDN Se1/0/0:15 Q931: call_disc: PI received in disconnect; Postpone sending RELEASE for callid 0x40BE
*Mar 3 11:51:31.025: ISDN Se1/0/0:15 Q931: TX -> RELEASE pd = 8 callref = 0xE48D
*Mar 3 11:51:31.081: ISDN Se1/0/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x82B4
Channel ID i = 0xA9839F
Exclusive, Channel 31
*Mar 3 11:51:31.185: ISDN Se1/0/0:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x648D
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide