ISDN BRI and CCM issue

[Seifeddine-Tlili]

HI all,

recently i tried to configure an ISDN connection with CallManager and it works fine but i'm stuck in something and thanks for ur previous posts by the way

I have a range of number from my SP like:

from 555501 to 555509 and i want that a predefined IP Phones like extension 4000 to use a specific PSTN number for inbound and outband Call and with an anology from the FXO conf i set up the:

Destination-pattern 9T for outband call

and

Connection plar opx 4000 for the inband

BUT with the BRI how it can be done?

Thanks in advance for all

[gogasca]

You can configure the BRI either as MGCP or H323

If H323 then configure a dial-peer pots with direct inward dial then a voip to fwd the number directly to ccm

If MGCP Just configure proper CSS and incoming settings for Voice Port

[Seifeddine-Tlili]

thanks for your reply but if the user want to use a specific number as his personnel PSTN number i mean for example if DN 4000 want only to use the PSTN number 555022 as the outband call ?

[Seifeddine-Tlili]

Hi is anyone there :) and thanks again for ur post Sir.