08-02-2010 09:50 PM - edited 03-16-2019 12:02 AM
Hi All I have 2 branches
HQ and BR01 and the following configuration:
HQ_DP (device pool) ---->> HQ_Region ----->> HQ_MRGL----> HQ_MRG { Software Conference and Transcoder01)
BR_Region ----->> BR_Region ----->> BR_MRGL------>> BR_MRG{ Transcoder 02}
I am not able to make any conference unless I make one of the transcoder in the default Media Resource Group, Which is not acceptable because I will not be able to manage the resources.
Any suggestions please ??
08-03-2010 06:18 AM
Assuming you're using G729 the only solution if you intend to use a SW CFB is to switch to G711.
The device that would need the XCODER would be the CFB and you would need to use it only at HQ.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
08-05-2010 04:12 PM
Thank you for your reply, and sorry because I reply late
I read this before but can you tell me why if I do this it will solve my problem ?
why if used Transcoder in default MRGL it solved my problem?
I need to understand why? because the customer will ask me to give justification
08-06-2010 06:11 AM
Again, I'm just assuming this with the little info you provided.
SW CFB can only handle G711, unless you send G711, a XCODER is required to join any kind of conference.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
08-06-2010 09:22 AM
let us say I have two sites as the following:
1- one software conference bridge just located in the HQ, no SW conference bridge in the remote site
2- two transcoders one in each site.
3- two Media resources group list, each one contains: SW conference bridge - located in HQ and transcoder.
the sw conference in HQ device pool and region.
I am not able to make any conference.
regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide