06-06-2012 10:16 AM - edited 03-16-2019 11:32 AM
Is the port marked "For maintenance only" the console port? Since the package didn't came with any console cable, I used the usual console access with the 38400 baud, but not successful.
I changed the baud to 9600 via SSH, the same! The "xoncifuration" shown the SerialPort Mode is on. Any ideas what the problem could be?
06-07-2012 10:13 AM
Jack,
This community does not provide technical support and is not staffed with technical support experts. I recommend you post this and future technical support questions to the Cisco Support Community (https://supportforums.cisco.com/index.jspa) under the "Telepresence" section where our Cisco technical support experts provide assistance. Another option is to open a ticket with the Cisco Technical Assistance Center (www.cisco.com/go/support) to get expert assistance.
We do encourage you to participate in the Cisco Collaboration Community and to also join our Cisco Collaboration User Group program! In the community, we encourage your discussion/sharing around collaboration topics and Cisco Collaboration Solutions, including business and IT requirements, industry trends, process, culture/organization issues, how collaboration can be used to transform businesses, vendor selection, adoption, training, architecture, licensing, and product features/functionality. If you are a customer or partner, you can also join the user group program to be eligible for member-only events and influence product direction.
We hope to hear from you again.
Kelli Glass
Moderator for the Cisco Collaboration Community
06-07-2012 11:35 AM
Thanks! Re-post the question to the support community!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide