TESTING FXO CARDS.

[Ejiroro oki]

Hello All,

Please I have lots of FXO Cards I want to test. I am not okey with just show diag or show inventory as my Router can see the cards. I want to be able to dial into the cards or Router,I mean the telephone line connected to the fxs end (I have both fxs and fxo, someone on this forum (Mr Humza.Khan7) has giving me good info on how to test the fxs card only which really work ,thanks a million to him but I am stock on testing the fxo cards)

Please I would appreciate any help on how to test the fxo only or testing both fxs&fxo cards together on the Router by being able to dial into the router or a handset connected to the fxo while you have a line(pstn) connected to the fxs.

Any help will be highly appreciated.this forum has really been helpful to me.

Many thanks in advance.

Kaycee

[Jorge Armijo]

You can connect the FXS-FXO back to back and create few dial-peers, then maybe by configuring an IP Phone and some translations make a call that will go out through the FXS coming back on FXO and a connection PLAR to the IP Phone, you should see a call coming into your IP Phone, your original call

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

[Ejiroro oki]

Thanks for your quick response,highly appreciated. I will appreciate a working config as I have followed the cisco document on how to configure this card but it did not work for me,it is also my first time.

I will also be gratefull if you will be kind enough to help me with a working config for the back  to back connection or just to test only the fxo card,all I want is to be able to dial into the card. I have been able to test only the fxs card by creating dialing peers and I can make call through the fxs but I am stock on the fxo.

Thanks

Kaycee