432
Views
0
Helpful
1
Replies
CCNA Pearson Network Simulator IPv6 Issues
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2025 03:47 PM
Another question for the Pros for Lab IPv6 Routing in Chapter 24 (1/e) I have completed the entire Lab got 100% all pings working Except for PC4 pinging PC1 R4 can Ping PC1 but the tracert just stops dead at R4's Gi0/0 interface. There are no Access-lists that I can see, and I even tried implementing static routes from R4 to R1. No luck. What am I missing here, or is the Pearson Network Simulator a little buggy?
Again, thanks in advance and I hope I am not missing something super basic.
Sincerely
Nic
Labels:
- Labels:
-
IPv6 Configuration
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-22-2025 04:48 PM
Hi @Nic31 ,
I think the fact that you can ping but not traceroute is probably a network simulator limitation.
Regards,
Harold Ritter, CCIE #4168 (EI, SP)
Harold Ritter, CCIE #4168 (EI, SP)
