We have a router 7600. Our IPv4 connection works fine. It´s connected with a IPS and a Nexus 7k that acts as a Router Reflector for BGP.
We got a IPv6 range and a address from our ISP. We are working to activate IPv6.
Everything is configured, link up...
The problem is that when we added the COPP policies for IPv4 the active the IPv6 BGP session stops to work and we can´t ping the ISP interface neither nx7k.
Since we remove the copp policy it starts to work again.
We configured copp specific to ipv6 but the behaviour is the same. We also tried to insert ip any any in the access-lists, but still not working. I really don´t know why a IPv4 COPP policy would affect the IPv6 stack. If we left only the copp for IPv4 it doesn´t work.
Any ideas? Is something wrong in the COPP configuration?
It´s the first ipv6 that we are trying to get online.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...