Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I´m trying to configure a 7821 with an third-party server.
After boot it ends at "Unprovisioned". I did some packet capture to check it.
It talks with server and after sometime it ends with server sending the:
"Status: 603 Declined (No dialgog...
Hello,We need to configure a IP Phone with public address and to do it we need to configure some NATs. The SIP Server is at Internet.One of the solutions that is possible is to use a SIP Proxy. Does anyone knows if Cisco ASA can be configured as a SI...
Hello, Checking configuration int some routers we found some ipv6 neighbors inside address family ipv4. It´s a 7606-S with version 15.3(1)S2.I was searching for the way to remove only the neighbor ipv6 inside this ipv4 address family. The neighbors a...
Hello, The version 3.0(0)A5(1.2) is vulnerable to these CVEs. I was looking for fix but it´s hard to find good information at Cisco Release Notes.the old versions: http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/ace/vA2_3_x/R...
Hello, We have one router with 2 links to same ISP. We have 1 bgp neighbor for each link.So, at this router we have 2 links and 2 neighbors with same ISP. And this router have conections with a router reflectorFirst, we are trying shutdown the router...
Thanks for all answers.I'm guessing about this "SIP aware NAT". Is possible to configure it on ASA?I´m still trying to figure out how to deploy it with few infrastructure changes.
Hi Felipe,Thanks for the answer,There isn´t information about A5(3.0) in the bug description. Is there any public Cisco document about CVE-2005-2969?Regards,
########UPDATE########Since version 6.x Cisco added a feature called table-map.It works like distributed lists and did what I needed. We are using it already. Info at link above:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/nx-os/un...
So I will apply the filter-list soon.I will use a route-map and prefix-list and "in" direction.I guess that I need to clear ospf routing table to make filter-list work.I found two ways to do IT.restart ospf XXXorclear ip ospf neighbor neighborID vrf ...
