06-26-2012 03:49 AM - edited 03-01-2019 05:35 PM
Hi Experts,
i want help to migrate all the public ip addresses to ipv6 .
What are the thinks i should taken care??
Thanks
Vipin .
06-26-2012 07:23 AM
Hi,
One thing to consider is routing.
If the public IP addresses are hosted on an ASA firewall then this device does not as yet support dynamic IPv6 routing.
Therefore if you want to route to the IPv6 addresses of these devices from within your internal network you will need to inject a static route into your routing table.
Cheers
Sean
06-27-2012 12:41 AM
Hi,
What we are going to do is one to one maping in our edge router..
Thanks and Regards,
Vipin
06-27-2012 10:14 PM
Hi experts..
I need to give our servers with IPV6 IP address. curretly all the servers are NATed with public IPs.
We want to these public IPs to IPv6 addresses.. any idea?
we are having a setup as.. switches--Firewall--Router--ISP
Kindly suggest u r valid opinions.
Thanks and Regards,
Vipin
06-28-2012 06:12 AM
So do you have a pool of global IPv6 addresses?
If so assign these addresses to your servers as required.
Are you plannig to keep your IPv4 addresses? If so you can run dual stack IPv4/IPv6 on these servers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide