Hi, im trying to implement IPV6 SLAAC on both routers in order to give the autoconfiguration to the rest of the laptops. I went trough the method but no luck so far, when I go to autoconfig for ipv6 on the computers nothing pops up.
Thanks in advance
Solved! Go to Solution.
Hi @Mohax ,
To enable IPv6 on the router you must enter the ipv6 unicast-routing command
Then, within the interface or subinterface, as the case may be, enter the command ipv6 enable
Then, assign an IPv6 address segment to the network and assign it the eui-64 method
About eui-64, I leave this link to the community:
I have attached the exercise with the activation of this method on your PCs
Regards
Hi @Mohax ,
To enable IPv6 on the router you must enter the ipv6 unicast-routing command
Then, within the interface or subinterface, as the case may be, enter the command ipv6 enable
Then, assign an IPv6 address segment to the network and assign it the eui-64 method
About eui-64, I leave this link to the community:
I have attached the exercise with the activation of this method on your PCs
Regards