Hi,
I configured IPv6 in dual-stack mode on my network and now I have to configure that in the data center area.
In the data center I have a vPC domain configured with OSPFv2 and VRRP routing.
- Is there a problem configuring IPv6-IPv4 dual stack in an existing vPC domain?
- What should I consider when implementing IPv6 in an existing vPC domain?
- Is there any risk of service disruption when configuring dual stack in an existing vPC domain?
current vpc configuration
SW_1 | SW_2 |
feature vpc ! vpc domain 11 peer-switch role priority 125 peer-keepalive destination 1.1.1.1 source 1.1.1.2 vrf keepalive delay restore 5 peer-gateway auto-recovery ip arp synchronize ! | feature vpc ! vpc domain 11 peer-switch role priority 123 peer-keepalive destination 1.1.1.2 source 1.1.1.1 vrf keepalive delay restore 5 peer-gateway auto-recovery ip arp synchronize ! |