cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2630
Views
0
Helpful
4
Replies

No IPv6 Commands Cisco 2821XM

kennygd2010
Level 1
Level 1

I'm unable to configure anything IPv6 related on my Cisco 2821XM router. When I'm in config mode and enter a "?" I do not see anything relating to IPv6. I'm currently running the below firmware. Any help would be appreciated.

Cisco IOS Software, 2800 Software (C2800NM-ADVSECURITYK9-M), Version 15.1(4)M7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Mon 16-Sep-13 00:31 by prod_rel_team

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

Router1 uptime is 2 hours, 10 minutes
System returned to ROM by power-on
System image file is "flash:c2800nm-advsecurityk9-mz.151-4.M7.bin"
Last reload type: Normal Reload

______________________________________________________

Router1#show ip?
ip ipam ipc iphc-profile

Router1#show ip

__________________________________________________

Router1#show running-config
Building configuration...

Current configuration : 5839 bytes
!
! Last configuration change at 13:30:34 UTC Thu Apr 20 2017 by kdillon
version 15.1
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname Router1
!
boot-start-marker
boot-end-marker
!
!
enable secret 4
enable password 7
!
no aaa new-model
!
!
crypto pki token default removal timeout 0
!
!
dot11 syslog
ip source-route
!
!
ip cef
ip dhcp excluded-address 172.20.100.2 172.20.100.20
!
ip dhcp pool LAN
network 172.20.100.0 255.255.255.0
domain-name LAN
dns-server 4.2.2.2
default-router 172.20.100.1
!
!
!
ip domain name CiscoTest
!
multilink bundle-name authenticated
!
!
!
!
license udi pid CISCO2821 sn
username kdillon password 7
username jconroy password 7
!
redundancy
!
!
!
!
!
!
!
!
!
interface GigabitEthernet0/0
ip address dhcp
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 172.20.100.1 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
ip nat inside source list NAT_ADDRESSES interface GigabitEthernet0/0 overload
ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0 dhcp
!
ip access-list standard DBC_WAN
permit
permit 0.0.0.31
permit 0.0.0.15
permit 0.0.0.15
permit 0.0.0.15
permit 0.0.0.15
ip access-list standard NAT_ADDRESSES
permit 172.20.100.0 0.0.0.255
!
!
!
!
snmp-server community WiFiRocks RO
snmp-server community WiFiSucks RW
snmp-server community WiFiFeeRocks RW
snmp-server community KenD1Rocks RO
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps vrrp
snmp-server enable traps ds1
snmp-server enable traps call-home message-send-fail server-fail
snmp-server enable traps tty
snmp-server enable traps eigrp
snmp-server enable traps ospf state-change
snmp-server enable traps ospf errors
snmp-server enable traps ospf retransmit
snmp-server enable traps ospf lsa
snmp-server enable traps ospf cisco-specific state-change nssa-trans-change
snmp-server enable traps ospf cisco-specific state-change shamlink interface
snmp-server enable traps ospf cisco-specific state-change shamlink neighbor
snmp-server enable traps ospf cisco-specific errors
snmp-server enable traps ospf cisco-specific retransmit
snmp-server enable traps ospf cisco-specific lsa
snmp-server enable traps flash insertion removal
snmp-server enable traps c3g
snmp-server enable traps adslline
snmp-server enable traps ds3
snmp-server enable traps envmon
snmp-server enable traps icsudsu
snmp-server enable traps isdn call-information
snmp-server enable traps isdn layer2
snmp-server enable traps isdn chan-not-avail
snmp-server enable traps isdn ietf
snmp-server enable traps ds0-busyout
snmp-server enable traps ds1-loopback
snmp-server enable traps ethernet cfm cc mep-up mep-down cross-connect loop config
snmp-server enable traps ethernet cfm crosscheck mep-missing mep-unknown service-up
snmp-server enable traps vstack
snmp-server enable traps license
snmp-server enable traps disassociate
snmp-server enable traps deauthenticate
snmp-server enable traps authenticate-fail
snmp-server enable traps dot11-qos
snmp-server enable traps switch-over
snmp-server enable traps rogue-ap
snmp-server enable traps wlan-wep
snmp-server enable traps rf
snmp-server enable traps bgp
snmp-server enable traps memory bufferpeak
snmp-server enable traps cnpd
snmp-server enable traps config-copy
snmp-server enable traps config
snmp-server enable traps config-ctid
snmp-server enable traps entity
snmp-server enable traps fru-ctrl
snmp-server enable traps resource-policy
snmp-server enable traps event-manager
snmp-server enable traps frame-relay multilink bundle-mismatch
snmp-server enable traps frame-relay
snmp-server enable traps frame-relay subif
snmp-server enable traps hsrp
snmp-server enable traps ipmulticast
snmp-server enable traps isis
snmp-server enable traps msdp
snmp-server enable traps mvpn
snmp-server enable traps pim neighbor-change rp-mapping-change invalid-pim-message
snmp-server enable traps pppoe
snmp-server enable traps cpu threshold
snmp-server enable traps rsvp
snmp-server enable traps syslog
snmp-server enable traps cef resource-failure peer-state-change peer-fib-state-change inconsistency
snmp-server enable traps l2tun session
snmp-server enable traps l2tun pseudowire status
snmp-server enable traps vtp
snmp-server enable traps aaa_server
snmp-server enable traps atm subif
snmp-server enable traps bfd
snmp-server enable traps firewall serverstatus
snmp-server enable traps isakmp policy add
snmp-server enable traps isakmp policy delete
snmp-server enable traps isakmp tunnel start
snmp-server enable traps isakmp tunnel stop
snmp-server enable traps ipsec cryptomap add
snmp-server enable traps ipsec cryptomap delete
snmp-server enable traps ipsec cryptomap attach
snmp-server enable traps ipsec cryptomap detach
snmp-server enable traps ipsec tunnel start
snmp-server enable traps ipsec tunnel stop
snmp-server enable traps ipsec too-many-sas
snmp-server enable traps nhrp nhs
snmp-server enable traps nhrp nhc
snmp-server enable traps nhrp nhp
snmp-server enable traps nhrp quota-exceeded
snmp-server enable traps ipsla
snmp-server enable traps vrfmib vrf-up vrf-down vnet-trunk-up vnet-trunk-down
!
!
control-plane
!
!
!
line con 0
line aux 0
line vty 0 4
access-class DBC_WAN in
password 7
logging synchronous
login local
transport preferred ssh
transport input ssh
line vty 5 15
login
transport preferred ssh
transport input all
!
scheduler allocate 20000 1000
end

4 Replies 4

kuntal.ghosh
Level 1
Level 1

Hi ,

Please check the IOS version . It might not support IPV6.

I've looked up the firmware version and there are multiple IPv6 features that can be enabled. I have also seen websites with users who have the same router which is running IPv6. Does anyone know if there is a different firmware I should be using?

If I remember right, you need at least the "Advanced IP Services" Image for IPv6 on the ISR G1.

He's right, advanced ip services or advanced enterprise services is required for IPv6

=> Cisco Feature Navigator

http://cfn.cloudapps.cisco.com/ITDIT/CFN/jsp/index.jsp

Review Cisco Networking for a $25 gift card