PPoE Dual Stack CDR

[maileh]

Hi All

We have dual stack pppoe and we currently use the two standard attribute below for our Users CDR with no problem.

*Oct 15 09:16:03.417: RADIUS: Acct-Input-Octets [42] 6 48220
*Oct 15 09:16:03.417: RADIUS: Acct-Output-Octets [43] 6 71629

Now after enabling the ipv6 i see these two extra Cisco Attibute on the Radius Packet send from my BRAS to my Freeradius Server.

*Oct 15 09:16:03.417: RADIUS: Cisco AVpair [1] 30 "acct-input-octets- ipv6=25837"
*Oct 15 09:16:03.417: RADIUS: Cisco AVpair [1] 31 "acct-output-octets -ipv6=44687"

My question.

1. Are these extra ipv6 counter already included on the standard attribute reading before or it is separate ?. If it is laready included then everything will be as is it at the moment. If it is not then appreciate if someone could share information on how this Cisco attribute is to be processed by Freeradius Server.

Note:

I have ask this question on Freeradius Mailing List and they said it is nor a Standard Attribute and i have to come to Cisco and ask there. So basically that is why my question.

[a.alekseev]

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r6-0/bng/configuration/guide/b-bng-cg60xasr9k/b-bng-cg60xasr9k_appendix_01010.pdf
you could try to compare
acct-input-octets- ipv6
acct-input-octets- ipv4
acct-input-octets

[maileh]

Thanks alekseev

My BRAS is a Cisco ASR 1001-X with Cisco IOS XE Software, Version 03.13.02.S .

I have done this command 

#aaa accounting send counters ipv6 , and i can see the ipv6 counter . However i do not see the other Cisco Specific AVP ipv4 couter attribute .

Can you suggest what command should i need to enable to reviece the Cisco AVP ipv4 counter as well.

Thanks