cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1288
Views
2
Helpful
2
Replies

AXL API Ring setting (Phone Active) "Beep Only"

Ring setting (Phone Active) "Beep Only" How do i set this in AXL API?

I have found  XPhoneLine.setRingSetting(value); but this only sets for Idle.

Call Manager Version = ( 10.5.2.12901(1) )

setting.jpg

1 Accepted Solution

Accepted Solutions

TDoan
Level 1
Level 1

Hi Brian,

You can use updatePhone (AXL API) to update the ring setting

Example:

        <soapenv:Envelope xmlns:soapenv="http://schemas.xmlsoap.org/soap/envelope/" xmlns:ns="http://www.cisco.com/AXL/API/10.0">

            <soapenv:Header/>

                <soapenv:Body>

                   <ns:updatePhone sequence="1">

                       <uuid> + ADeviceUId + </uuid>

                         ....

                         ....

                       <Lines>

                          <line>

                            <uuid> + ALineUUId </uuid>

                                  ....

                                  ....

                            <ringSetting>Ring</ringSetting>    ----> You need to set a value here (Ring, Flash Only or Ring One, ...

                                                                                      This is set for Ring Setting (Phone Idle)

                            <consecutiveRingSetting>Beep Only</consecutiveRingSetting>  ---> This is set for Ring Setting (Phone                                                                                                                                       Active)

                                  ....

                          </line>

                       </lines>

                   </ns:updatePhone>

                </soapenv:Body>

         </soapenv:Envelope>

Hope that would help you.

Regards

Thuy Doan

View solution in original post

2 Replies 2

TDoan
Level 1
Level 1

Hi Brian,

You can use updatePhone (AXL API) to update the ring setting

Example:

        <soapenv:Envelope xmlns:soapenv="http://schemas.xmlsoap.org/soap/envelope/" xmlns:ns="http://www.cisco.com/AXL/API/10.0">

            <soapenv:Header/>

                <soapenv:Body>

                   <ns:updatePhone sequence="1">

                       <uuid> + ADeviceUId + </uuid>

                         ....

                         ....

                       <Lines>

                          <line>

                            <uuid> + ALineUUId </uuid>

                                  ....

                                  ....

                            <ringSetting>Ring</ringSetting>    ----> You need to set a value here (Ring, Flash Only or Ring One, ...

                                                                                      This is set for Ring Setting (Phone Idle)

                            <consecutiveRingSetting>Beep Only</consecutiveRingSetting>  ---> This is set for Ring Setting (Phone                                                                                                                                       Active)

                                  ....

                          </line>

                       </lines>

                   </ns:updatePhone>

                </soapenv:Body>

         </soapenv:Envelope>

Hope that would help you.

Regards

Thuy Doan

consecutiveRingSetting <-- this was key

Not sure why the names are so different from the GUI

thanks Thuy Doan