Hi,
How can I lookup real time bandwidth utilization for specific subscriber?
we have subscribers like that:
#show subscriber session username 100.64.4.248
Type: DHCPv4, UID: 2883, State: authen, Identity: 100.64.4.248
IPv4 Address: 100.64.4.248
Session Up-time: 08:14:30, Last Changed: 08:14:30
Switch-ID: 20898104
Policy information:
Authentication status: authen
Active services associated with session:
name "IPoE10Mbps1SLA", applied before account logon
Rules, actions and conditions executed:
subscriber rule-map IPoE-SUBSCRIBER-CONTROL
condition always event session-restart
10 authorize aaa list IPoE-AAA identifier source-ip-address
subscriber rule-map default-internal-rule
condition always event service-start
1 service-policy type service identifier service-name
Classifiers:
Class-id Dir Packets Bytes Pri. Definition
0 In 920627 231996802 0 Match Any
1 Out 1762368 2205745378 0 Match Any
Template Id : 10
Features:
Idle Timeout:
Class-id Dir Timeout value Idle-Time Source
1 Out 43300 00:00:00 Peruser
Accounting:
Class-id Dir Packets Bytes Source
0 In 920625 211742640 Peruser
0 In 920625 211742640 IPoE10Mbps1SLA
1 Out 1670470 2031493289 Peruser
1 Out 1670470 2031493289 IPoE10Mbps1SLA
Policing:
Class-id Dir Avg. Rate Normal Burst Excess Burst Source
0 In 10485500 1966080 3932160 IPoE10Mbps1SLA
1 Out 10485500 1966080 3932160 IPoE10Mbps1SLA
Configuration Sources:
Type Active Time AAA Service ID Name
USR 08:14:30 - Peruser
SVC 08:14:30 1560283644 IPoE10Mbps1SLA
INT 08:14:30 - TenGigabitEthernet0/0/1.502Subscriber session configured on RADIUS
Attributes:
Acct-Interim-Interval=240
Framed-IP-Address=100.64.4.248
Idle-Timeout=43300
cisco-avpair=subscriber:accounting-list=IPoE-AAA
cisco-SSG-Account-Info=AIPoE10Mbps1SLA
Acct-Interim-Interval=900
Idle-Timeout=3600
cisco-avpair=subscriber:accounting-list=IPoE-AAA
cisco-SSG-Service-Info=QU;;1048576;;196608;;393216;;D;;1048576;;196608;;393216
Subscribers terminated on interfaces like that:
interface TenGigabitEthernet0/0/1.502
description "== ACCESS SUBSCRIBERS INTERFACE SVLAN:502 =="
encapsulation dot1Q 502 second-dot1q any
ip dhcp relay information option server-id-override
ip dhcp relay information option-insert
ip dhcp relay information policy-action replace
ip unnumbered Loopback0
ip helper-address 10.1.1.1
ip nat inside
ip flow monitor NETFLOW-TO-COLLECTOR input
no ip route-cache same-interface
arp timeout 43200
service-policy type control IPoE-SUBSCRIBER-CONTROL
ip subscriber l2-connected
initiator unclassified mac-address
initiator dhcp
end
03.16.08.S
