Hi
Just wanted to get someone to give me some quick pointers on the following task:
I have an me3400 with fa0/1 as a UNI.
also I have Gig0/1 as NNI.
I have set the commands on the switch as
ethernet cfm ieee
ethernet cfm global
ethernet cfm domain testnet level 4
!
ethernet evc cust1
oam protocol cfm svlan 10 domain testnet
!
interface FastEthernet0/1
switchport access vlan 10
switchport mode dot1q-tunnel
speed 100
duplex full
l2protocol-tunnel cdp
l2protocol-tunnel lldp
l2protocol-tunnel stp
l2protocol-tunnel vtp
!
interface GigabitEthernet0/1
port-type nni
switchport mode trunk
ethernet cfm mip level 4 vlan 10
!
so this is the minimal functionality that I am after.
What else do I need to do to link the fa0/1 port to the EVC and enable an UP MEP and CC on it?
the end goal initially is to propagate link loss when the UNI is disconnected so that the remote me3400 brings down its UNI.
any help please.