This my design:
rep admin vlan 100 segment 100
RUNNWAY-2 configuration:
Interface g1/0/12
Switchport mode trunk
Rep segment 100 edge primary
Interface g1/0/11
Switchport mode trunk
Rep segment 100 edge secondary
B-MCR configuration:
Interface g1/1/2
Switchport mode trunk
Rep segment 100
Interface g1/1/4
Switchport mode trunk
Rep segment 100
MCR configuration:
Interface g1/1/2
Switchport mode trunk
Rep segment 100
Interface g1/1/4
Switchport mode trunk
Rep segment 100
this the error prompt at every interface :^
% Invalid input detected at '^' marker. which mean the rep command is not working on my CISCO switch 3850 and 3750
please advice
