Hello all..I am looking to create an MPLS lab for a project I have coming up that will leverage dual ISP's. One is easy, it will all be Ethernet while the other is not. I need to find a means of simulating T1/Bonded T1's etc.
I was looking at using an ME3600X 24CX for this. I am looking for confirmation that this should work for me? Is it possible to configure a T1 port as a L3 interface?
I stood up a rough topology in Dynamips, the AT&T MPLS will have the T's..so looking at the topology, the "ATT AS2001" will be the ME device where the CE will plug in.
Will the ME3600X work for this?
All IP's are obviously made up in Dynamips
