I have two MWR2941's seperated by several routed hops in a non MPLS enabled core. I have a GPRS toycell on one side and a BSC on the other (this is not important) and need to configure an E1 CESoPSN (or SAToP -- I don't care) pseudowire. I realize that I need a GRE tunnel between the two MWR's in order to get MPLS to work properly. I have the GRE tunnel configured and the pseudowire is up, but I can only get one-way traffic on the CEM interface, even though the physical interface shows two-way traffic. The configs are fairly plain. Here is the BSC side -- the toycell side is identical with the IP addresses changed:
In scaled EVPN deployments it can be wise to name ESI that way to represent the site/physical port/etc it is attached to. Thus on some remote location you can easily verify where particular route/MAC is coming from. Similar to phone numbers, where...
Want to enable Feature EPFT with “routing-protocols-enable”. However ,it is throwing an error and ask to configure the following command: “non-subscriber-interfaces mac” which once enabled drops the traffic without any penalty.
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...