05-04-2006 05:12 PM
Hi,
We installed a new 7609 in our lab for doing H-VPLS interop. The sw Version is IOS (tm) s72033_rp Software (s72033_rp-PSV-M), Version 12.2(18)SXD7.
I do not see the "no-split-horizon" option when trying to configure the remote spoke PE.
l2 vfi PE3-VPLS-A manual
vpn id 200
neighbor 20.0.0.1 encapsulation mpls <no-split-horizon>
Is there a version problem or some config issue ?
Thanks
AT
05-04-2006 05:19 PM
The hw info is as follows :-
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 2 2+4 port GE-WAN OSM-2+4GE-WAN+ JAB0847061N
5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAL0919113H
Mod Sub-Module Model Serial Hw Status
--- --------------------------- ------------------ ------------ ------- -------
5 Policy Feature Card 3 WS-F6K-PFC3BXL SAL09253GNF 1.6 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL09190TCD 2.5 Ok
05-04-2006 06:30 PM
This option was introduced in 12.2(18)SXE and is therefore not present in the version you are currently running.
Hope this helps,
05-05-2006 01:50 PM
I loaded 12.2(18)SXF4, and the option is there now.
Thank you!
05-26-2006 03:31 PM
Hi,
We have the following card installed in the Cisco 7609 :-
OSM-2+4GE-WAN
I do not see the "switchport" commands on the 4 WAN ports ? Is this normal ? How do I enable VLANs plus STP on the 4 WAN ports ?
I only see the "switchport" commands on the first 2 LAN ports.
IOS 12.2(18)SXF4
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide