cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1362
Views
0
Helpful
0
Replies

How do I force a Interface/XConnect up?

Philip Olsson
Beginner
Beginner

Hello,

I'm currently deploying some ISR 1900 as MPLS hand off with xconnect and would like to do testing to make sure that the configuration is correct, but I can not find a way to force my customer facing interface in a up state without them plugging something in.

Se below for configuration

#sh xconnect  all

Legend:    XC ST=Xconnect State  S1=Segment1 State  S2=Segment2 State

  UP=Up       DN=Down            AD=Admin Down      IA=Inactive

  SB=Standby  RV=Recovering      NH=No Hardware

XC ST  Segment 1                         S1 Segment 2                         S2

------+---------------------------------+--+---------------------------------+--

DN     ac   Gi0/1(Ethernet)              DN mpls x.x.x.x:10000          DN

interface GigabitEthernet0/1

description "Customer interface"

no ip address

duplex auto

speed auto

xconnect x.x.x.x 10000 pw-class ETH-PW

end

And I would like to force it up so I can verify that configuration and that the eompls is working?

I tried the "loopback mac/driver" command under interface, but saw no reaction from the box.

Software version: c1900-universalk9-mz.SPA.151-4.M4.bin

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: