We have MPLS backbone, the backbone is connected to two internet service providers (ISP1 and ISP2), PE1 receives the default route from ISP1 and PE2 receives the default route from ISP2. Both PEs then advertise the default route to other VRFs (Customers).
Now, we want to import ISP1 default route into PE2 with higher Local Pref (120), to make PE1 is the preferred route for outbound internet traffic. We want the changes to be done on PE1 and PE , we don't want to make any changes to customer VRFs.
In the attached diagram, the config in BLACK is the current config, the config in GREEN is the new config I'm adding to make PE2 imports and prefers PE1 default route over ISP2 route. Does this configuration look good?
XR-vm - CLI's
look for any process crash, review time stamp[if it is too old, then no immediate action needed]
verify if standby state is Ready and NSR-Ready
show proc cpu | exclude " 0%"
It's been a long standing ask for XR to support conditional route advertisements in BGP.
The expected option of using the
option in RPL currently can only be used at the default-inf...
On IOS-XR, Quality of Service has an extension to WRED (Weighted Random Early Detection) called Explicit Congestion Notification (ECN). ECN will mark packets instead of dropping them when the average queue length exceeds a specific threshold value. When c...
Technical Guide to Pre-Defined NAT.
In traditional NAT, due to the government regulations logging the CGN translations is mandatory and this is a huge cost incurrence. In Pre-defined NAT, the translations are known upfront, hence there is no nee...