Hello everybody
I'd like to setup VPLS between 3 points. Our switches are 6504E with Sup720-3BXL
and the the following modules and IOS:
6504# show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 2 Supervisor Engine 720 (Active) WS-SUP720-3BXL SAL134322F9
3 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL1219PUZU
4 48 48-port 100FX SFP Ethernet Module WS-X6148-FE-SFP SAL1216N2QD
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 001a.a22d.90c4 to 001a.a22d.90c7 5.9 8.5(3) 15.1(2)SY1 Ok
3 0021.5593.b6c8 to 0021.5593.b6df 3.1 12.2(18r)S1 15.1(2)SY1 Ok
4 001f.6cae.3340 to 001f.6cae.336f 3.3 8.4(1) 15.1(2)SY1 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Policy Feature Card 3 WS-F6K-PFC3BXL SAL134325LA 1.11 Ok
1 MSFC3 Daughterboard WS-SUP720 SAL13421LZN 4.0 Ok
3 Centralized Forwarding Card WS-F6700-CFC SAL1218PC9H 4.0 Ok
my problem is that when i configure VPLS according to CISCO-Documents, the VFI and L2 VCs comes up,
but i can't ping between end points located in Customer-Switches.
Is any problem with Hardware-Configuration, IOS or platform support ?
I have just studied the following link about this, but i'm not sure about that. (at least i can't believe that ! )
http://afnog.org/pipermail/afnog/2013-February/001006.html
Any comments will be appreciated. thanks
Arshin
