Hi,
When i put show mpls traffic-eng topology command i see reservation only on outgoing interfaces of the router. Why? Why not the incoming interfaces?
link[0]: Broadcast, DR: 3.3.3.53, nbr_node_id:12, gen:40
frag_id 1, Intf Address:3.3.3.35
TE metric:1, IGP metric:1, attribute flags:0x0
SRLGs: None
physical_bw: 100000 (kbps), max_reservable_bw_global: 75000 (kbps)
max_reservable_bw_sub: 0 (kbps)
Global Pool Sub Pool
Total Allocated Reservable Reservable
BW (kbps) BW (kbps) BW (kbps)
--------------- ----------- ----------
bw[0]: 0 75000 0
bw[1]: 0 75000 0
bw[2]: 0 75000 0
bw[3]: 0 75000 0
bw[4]: 0 75000 0
bw[5]: 0 75000 0
bw[6]: 0 75000 0
bw[7]: 0 75000 0
link[1]: Broadcast, DR: 2.2.2.32, nbr_node_id:3, gen:40
frag_id 2, Intf Address:2.2.2.32
TE metric:1, IGP metric:1, attribute flags:0x0
SRLGs: None
physical_bw: 100000 (kbps), max_reservable_bw_global: 75000 (kbps)
max_reservable_bw_sub: 0 (kbps)
Global Pool Sub Pool
Total Allocated Reservable Reservable
BW (kbps) BW (kbps) BW (kbps)
--------------- ----------- ----------
bw[0]: 0 75000 0
bw[1]: 0 75000 0
bw[2]: 0 75000 0
bw[3]: 0 75000 0
bw[4]: 0 75000 0
bw[5]: 0 75000 0
bw[6]: 0 75000 0
bw[7]: 70000 5000 0
Link 1 reservation is there but on link 0 NO RESERVATION. Why? Since link 0 is incoming interface and Link 1 is outgoing interface.of the tunnel.
