MPLS

Hi All,Does anyone know if label mapping messages from mLDP can use ISIS Address-family ipv4 multicast for RPF?  I know regular PIM message can use it for RPF but am not sure about mLDP label mapping messages.Thanks,DL

Hi everyone,i wonder if you can help as this issue I have is very frustrating to resolve.We have a HQ site configured with core mpls network. All internet browsing woks ok.We have a remote site connected via a WAN circuit that mpls runs over. the Rem...

Dear AllHow do I calculate the expected increase in CPU Load and Memory Consumption with ~150 ICMP Echo IP SLA Operations running simultaneously with 1 Sec Frequency.RegardsVarma

HI,I perfomed a install of license 10GEUpgrade on ME-3600X-24TS-M switch and "show license " command output is:Index 3 Feature: 10GEUpgrade        Period left: Life time        License Type: Permanent        License State: Active, Not in Use        L...

I have two MWR2941's seperated by several routed hops in a non MPLS enabled core. I have a GPRS toycell on one side and a BSC on the other (this is not important) and need to configure an E1 CESoPSN (or SAToP -- I don't care) pseudowire. I realize th...

I connected notebook with PE. But, I can't play multicast stream with VLC.Diagram:7609 (PE) - 7609 (AG) - 7609 (AC) - ME3400 (AC) - NotebookI see pim neighbor on PE:co7609s-6#sho ip pim vrf GTV-M neiPIM Neighbor TableMode: B - Bidir Capable, DR - Des...

Hi guys,We are in aprocess to implement the mpls l2 Vc on our network by replacing the qinq l2 structure in our field, for doing so we have to replace the present devices which takes some cost to the management.In the mean while, can i know what are ...

With Rahul Rammanohar  Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about packet capture capabilities of Cisco routers and switches.In May 2013, we created a video that includ...

Hi ,Could any one explain me what is Core MPLS LSP (It seems that it do not support any TE, LDP or other protocol) ?Thanks

DearsWould like your assistance please regarding below VPLS setupVPLS is between ASR9k & 7600 ES+ card. VC is up but CEs are not able to ping each others  Lab Topology CE <> Te0/1/0/3.55 ASR9K < -- mpls --> 7600 Gi4/2 <> CEAny ideas ?NoteASR9k & 7600...

i am trying to redistribute BGP routes into EIGRP . On the router the routes are correct and leaned via BGP and given preference but when i check at Core switch the EIGRP is given preference . I have tried to give redistributed BGP higher metric but ...