03-08-2015 11:36 AM - edited 03-10-2019 10:31 PM
Dears,
I have two redundant WLC and two ISE configured as primary and secondary.
I configured the Dot1x and users authenticated successfully, but my issue that i'm still receiving this error message (11007 could not locate network device or aaa client).
Any ideas or suggestions highly appreciated,
03-08-2015 05:29 PM
Hello Ali-
Are both of the WLCs listed as NADs under ISE (Administration > Network Devices)? And have you confirmed that the AAA secret matches on both ends?
Thank you for rating helpful posts!
03-08-2015 11:25 PM
Hi Neno,
the AAA are matches.
Regarding the NADs (2x WLC) are listed under the ISE, and I think this is my issue.
When I configured the SSO on the WLCs now I can ping only one ip for the both WLCs. So should I configured two NADs under the ISE with same IP?
03-09-2015 09:22 AM
What type of controllers are you using? And are you running them in HA? (Behind one virtual IP address)
Thank you for rating helpful posts!
03-09-2015 01:11 PM
I have Cisco 5508 WLCs with HA (SSO) configuration.
So in ISE under NW devices I should put one WLC IP?
03-11-2015 08:43 AM
The last time I did this I had one IP per HA pair.
Thank you for rating helpful posts!
03-16-2015 02:30 AM
Active and standby WLC share same IP address so you can add it as NAD IP
03-09-2015 03:09 AM
Symptom:
RADIUS requests dropped due to failure reason "11007 Could not locate Network Device or AAA Client", even though they are successfully loaded in ISE.
Conditions:
Issue with Network Device import via CSV.
Known Affected Releases: | (2) |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide