802.1x and ACS

[Alejandro Cortes Rivera]

when implementig a 802.1x with a cisco ACS is necesary to work with certificates or it can just work with username and password?

[jafrazie]

It can work either way based on the EAP method selected.

[Alejandro Cortes Rivera]

But if I wanto to enable "PEAP" is says that a certificate must be installed, do you have a good guide to implemente 802.1x ACS 4.1?

[jafrazie]

Check here:

<http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00801df0e4.shtml>

Hope this helps,

[Alejandro Cortes Rivera]

But it works with certificates, I just wan to validate with username and password, is that possible?