Hello Mark,
All you need to do is, replace the existing CSAdmin.exe file with the new one. Here is the instrcuctions from the Read Me file:
Installtion Instructions:
-------------------------
1) Manually stop the CSAdmin Service
2) rename the /CSAdmin/CSAdmin.exe file
3) copy the patched CSAdmin.exe to /CSAdmin
4) Manually start the CSAdmin Service
Important - The patch must be installed on version 3.0(3.6) only and not other 3.0 releases.
If patch is installed on other ACS Version than 3.0(3.6), Backup and Restore isn't going to work and will result
in an error : "This backup file is not for this version of CiscoSecure"
To verify which version of CSAdmin is running use the following procedure:
1) net stop CSAdmin
2) cd /CSAdmin
3) run "csadmin -x"
4) net start CSAdmin
This will print out the exact version which should be 3.0(3.6)
Otherwise , a fresh upgrade to ACS3.0 FCS is needed prior to applying the patch
Just in case, if you need to access the Read me file and the .exe file, here is the link for this:
http://www.cisco.com/pcgi-bin/tablebuild.pl/cs-acs-win
To upgrade to acs 3.0.3, all you need is to run the setup.exe and follow the steps. Please, make sure to upgrade before you apply this patch.
I hope this helps ! Thanks,
Mynul
