04-30-2014 12:44 AM - edited 03-10-2019 09:40 PM
Hello there,
We're going to be implementing 802.1x on our network of some reaallly old switches (6509 Cat OS with MSFC 2). We use radius for AAA authentication and I've been reading that .1x uses radius. How is that going to work? Do I just add another radius server in my radius server command and, more importantly, will .1x work on Cat OS running 8.2.1? I've been trowling the forums and I can't seem to find anyone who's actually running .1x on the old Cat OS switches to see what kind of gotchas I can expect to run into.
Any advise, assistance would be greatly appreciated!
Thanks
Kiley
04-30-2014 05:29 AM
Please use the below document for 802.1x config.
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2950/software/release/12-1_9_ea1/configuration/guide/scg/Sw8021x.html
05-03-2014 08:34 PM
Salodh,
Thanks but that document is for a 2950 and we have a 6509 but, the good thing is I just found out our Tier 3 engineers will not be adding dot1x to the 6509 since it has only trunks - no access ports. Thanks very much for your reply!
05-06-2014 05:39 AM
FYI
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/42665-cat6500-1x-native-42665.html
https://supportforums.cisco.com/discussion/9730506/cat-6509-dot1x-and-switch-port-issues-sos
05-23-2014 03:07 AM
just to add you can find all the required information like issue what to expect on this page in the troubleshooting section
http://www.cisco.com/c/en/us/support/switches/catalyst-6500-series-switches/tsd-products-support-series-home.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide