Network Access Control

Does anyone have a good walkthrough on how to setup ACS 5.3 to authenticate wireless users over radius? I currently have the SSID pointing to a Microsoft IAS server and would like to move the authentication to be done via ACS.Thanks,Chris         

Hi All In a distributed deployment where there is more than one PSN's how do we have a common url for guest redirection when doing a CWA (assuming no load balancer is used for the PSNs)? usually the redirection url would be 'https://<ise01.fqdn/guets...

  HiI am running ACS 4.2 in my environment and configure TACACS for Cisco IOS devices. Now we have build cisco wilreless controller which we need to get authenticated with Radius. I have configured Radius on controller and ACS too but unable to login...

Good Afternoon, Our TACACS+ Svr is v3.3 on Win Svr 2k3.  I need to upgrade it to hopefully the newest version.  I see that anything newer than 4.x needs to go on a VM.  The documentation I've had little time to read only gives the requirements for th...

i have difficulities logging in to the acs server. I did repeat ping to the acs IP and and got replies with different TTL values. It looks like a pattern replies. When the TTL values is 63, im able to access the acs, but when TTL is 254, my connectio...

Hi All When I take a backup of primary, just the application backup, it is more than 10GB.Is that normal. I noticed there are no purge settings configured. But since this is just application backup, the monitoring logs should be considered under this...

Hello,Bug: CSCte30267Any idea how I can check the details for this bug? Has any release been developed to resolve this bug?Thanks.

Hi, i have some Problems setting up a dot1x authentification.In my lab i use 1 Client, 2 Switches and a RADIUS-Server.Client => Switch A => Switch B => RADIUSI have configured an interface vlan on switch A and switch B in the same vlan the RADIUS-ser...

Hi,I'm seeing some confusing behavior on 881 routers running IOS 15.2(4)M4 and was wondering if anyone could explain.We would like to run authentication violation restrict to only block unauthenticated devices, not shut down the interface.From interf...

Hi all, i am configuring cisco ISE to autenticate wireless clients using 802.1x . AP's are all lightweight managed by a cisco 5508 WLC . I would like to discriminate users accessing that wlan using mobile phones or tablet from users connecting using ...

Hi All, Does anyone has any experience with any script which can run in cli once the primary admin node fails and promote the secondary to become primary? ThanksG