ACS 3.1 & Cisco Work For Windows 6.0 compatibility

[lmalaguti]

Hi, I would like to know if it's possible install Cisco ACS 3.1 and Cisco Works For Windows 6.0 on the same server.

Many thanks in advance.

Luca

[wong34539]

Normally this information is avaialble in the product release notes. The release notes for ACS 3.1 are available at http://www.cisco.com/en/US/products/sw/secursw/ps2086/prod_release_note09186a00800e6edc.html. Though it is not a tested setup, I was unable to find any warnings either. I don't think that there should be any problems in running both ACS and Ciscoworks on a single pllatform. The only consideration is that of resources. These applications are rather demanding as far as system resources are concerned and running both on the same platform might degrade performance.

[mhoda]

It is possible, but not recommended at all and also not supported. ACS 3.1 should be installed in a dedicated server and so does Cisco Works. Again, ther e

should not be any resouce confliction issue.