ACS 3.2.1 - Evaluation Software Problems

[amarais]

Hi,

I've been experiencing problems with ACS 3.2.1 Eval software using Aironet Radius as authentication for Aironet Clients using PEAP Authentication. PEAP settings dissappear after Certificate has been installed and the Authority has been setup. After restarting ACS etting up of the PEAP settings ACS warns that a Certificate has not been installed.

H/W: Dual Processor Pentium III Xeons; 512MB Memory,

19GB Hard Drive

Software Specs: Windows 2000, Service Pack: 4

Any known issues?

[pradeepde]

Check out the following release note for the evaluation software for known issues,

http://www.cisco.com/en/US/products/sw/secursw/ps2086/prod_release_note09186a008018492b.html#1046573

[jihealis]

This document provides no information that I could see on the issue presented here. I, too, am having the same issue where the ACS server accepts the cert, and then fails to recognize it when trying to enable PEAP.

If anyone has solid information about this, please point us to it.