Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know of a document that shows what phone loads are compatible with which version of CM?I just want to make sure that when I upgrade to 4.1 that I cause the forced reset of all my phones just to get the new load.
When using a MeetMe conference on a 7935, there is no beep when people join the conference like there is on a 7960. What could be causing this? Is it a configurable parameter in CCM, or is it something on the 7935?
Has anyone else configured handheld devices to use your wireless network using PEAP, but no certificates? Instead authenticating with username/password/domain.All of Microsoft's documents say they support PEAP but none say how to configure it.
I have installed the Aironet 350 PC Card in my Dell Latitude running WinXP, using the Windows installed driver, the Cisco driver from CCO and the one on the CD, and each time I get a blue screen error noting a problem with ndisoui.sys.This seems to h...
I am running a 3005 and would like VPN clients to not use split tunneling and run all traffic, local LAN and Internet, through the VPN tunnel. Currently, I can get the local LAN traffic to work, but no Internet traffic is passing.On the 3005 I have ...
Thanks! It gets me close enough, I think.Right now I have P003-5-0-6, which isn't listed. So I suspect that it's been pulled for some reason I can't find yet. The next earlier version that is listed is not compatible, so it looks like I will be stuck...
Remember, too, that to connect two or more server in a intercluster trunk there must be no more than 50ms. This pretty much limits you to doing ICT over LAN environments, or VHS WAN connections.
This document provides no information that I could see on the issue presented here. I, too, am having the same issue where the ACS server accepts the cert, and then fails to recognize it when trying to enable PEAP.If anyone has solid information abou...
I'm beginning to wonder if the static default route on the 3005 pointing to the outside interface is what is causing my problem. I am thinking that the client machine looks up the address, the attempts to reach it, the 3005 decrypts the traffic and s...
The subnet for the VPN clients is private address space. The VPN concentrator has a direct connection to the internal router, and the inside interface is in the subnet of the client address space. The internal router shows the "client addresses" as...
